Experimental investigation of semiconductor losses in cryogenic DC-DC converters

Jia, Chunjiang (2008). Experimental investigation of semiconductor losses in cryogenic DC-DC converters. University of Birmingham. Ph.D.


Download (2MB)


As high-temperature superconductor technology approaches commercial applications, for example superconducting magnetic energy storage, superconducting fault current limiters, and superconducting rotary machines for marine propulsion, it is timely to consider the possibility of integrating the associated control equipment into the cryostat with the superconductor. This may bring benefits in terms of the performance of the power electronics or may enable other system benefits such as higher voltage lower current feedthroughs which reduce heat leakage into the cryostat. This Thesis studies the performance of several DC-DC power conversion techniques at temperatures down to 20 K. In particular hard switching, synchronous rectifier, zero-voltageswitching and multi-level circuit prototypes are examined, focusing on the losses in the semiconductor devices. The prototypes operated from 120 V and 500 V DC supplies at power levels up to 500 W using MOSFET devices and ultrafast, Schottky and silicon carbide diodes. The semiconductors were all in commercial TO220 packages. Although MOSFET on-state resistance was found to drop by a factor of approximately six at cryogenic temperatures, the device switching speed and switching losses were relatively insensitive to temperature. The diode on-state voltage increased by 20-30 % at low temperatures whilst reverse recovery and the associated losses decreased by a factor of up to ten. The total semiconductor losses in all prototypes reduced at low temperatures, typically exhibiting a minimum value in the region of 50-100 K. The performance of the hard switching and synchronous rectifier circuits was limited at cryogenic temperatures by switching losses, even though the dead time in the synchronous rectifier was adjusted to compensate for the increase in MOSFET gate threshold voltage at low temperatures. The zero-voltage-switching prototype offered the largest reduction in semiconductor losses at low temperatures, the losses were reduced to 18 % of the room temperature value. Furthermore, since the remaining losses were almost entirely due to MOSFET conduction, further reductions could be easily achieved by paralleling additional devices. The performance of the multi-level circuits was limited by switching losses and the large number of series connected devices; however, a zero-voltage-switching synchronous rectifier variant of the circuit was suggested to overcome some of these limitations.

Type of Work: Thesis (Doctorates > Ph.D.)
Award Type: Doctorates > Ph.D.
College/Faculty: Schools (1998 to 2008) > School of Engineering
School or Department: School of Engineering, Department of Electronic, Electrical and Systems Engineering
Funders: Other
Other Funders: Overseas Research Students Awards Scheme
Subjects: T Technology > TK Electrical engineering. Electronics Nuclear engineering
URI: http://etheses.bham.ac.uk/id/eprint/161


Request a Correction Request a Correction
View Item View Item


Downloads per month over past year